Supermicro H8QG6+-F / H8QGi+-F — Supermicro H8QG6+-F / H8QGi+-F Serverboard User Manual PDF

H8QG6/i+-F Serverboard User's Manual JI 2 C1/JI 2 C2 allows you to enable the I 2 C bus to communicate with the PCI- Express slot. For the jumpers to work properly, please set both jumpers to the same setting. If enabled, both jumpers must be enabled. If disabled, both jumpers must be disabled. See the table on the right for jumper settings. I2C to PCI-Express Slot Watch Dog Enable/Disable JWD1 enables the Watch Dog function, a system monitor that takes action when a software application freezes the system. Jumping pins 1-2 will have WD reboot the system if a program freezes. Jumping pins 2-3 will generate a non-maskable interrupt for the program that has frozen.

See the table on the right for jumper settings. Watch Dog must also be enabled in BIOS. Note: When Watch Dog is enabled, the user must write their own application software to disable the Watch Dog Timer. LAN1/2 Enable/Disable Change the setting of jumper JPL1 to enable or disable the LAN1 and LAN2 Ethernet ports. See the table on the right for jumper settings. The default setting is enabled. SAS Enable/Disable JPS1 allows you to enable or disable the SAS controller for the H8QG6+-F serverboard only. The default position is on pins 1 and 2 to enable SAS. See the table on the right for jumper settings.

2-22 I2C to PCI-Express Slot Jumper Settings (JI2C1/JI2C2) Jumper Setting Defi nition Closed Enabled Open Disabled Watch Dog Jumper Settings (JWD1) Jumper Setting Defi nition Pins 1-2 Reset Pins 2-3 NMI Open Disabled LAN1/2 En/Disable Jumper Settings (JPL1) Jumper Setting Defi nition Pins 1-2 Enabled Pins 2-3 Disabled SAS Enable/Disable Jumper Settings (JPS1) Jumper Setting Defi nition Pins 1-2 Enabled Pins 2-3 Disabled