Supermicro H8QG6+-F / H8QGi+-F — Supermicro H8QG6+-F / H8QGi+-F Serverboard User Manual PDF

H8QG6/i+-F Serverboard User’s Manual Legacy USB Support Select "Enabled" to enable the support for USB Legacy. Disable Legacy support if there are no USB devices installed in the system. "Auto" disabled Legacy support if no USB devices are connected. The options are Disabled, Enabled and Auto. IDE/SATA Confi guration OnChip SATA Channel This setting allows you to Enable or Disable the OnChip SATA channel. OnChip SATA Type Use this setting to set the OnChip SATA type. Options include Native IDE , RAID, AHCI and Legacy IDE. RAID Codebase This submenu appears when you choose "RAID" from the "OnChip SATA Type" setting above.

This setting allows you to select the codebase for using your RAID setup. Options are either Adaptec or DotHill . SATA IDE Combined Mode This setting allows you to Enable or Disable the SATA IDE combined mode. PATA Channel Confi guration This allows you to set PATA channel confi guration. Options include SATA as Primary or SATA as secondary. Primary/Secondary/Third IDE Master/Slave LBA/Large Mode LBA (Logical Block Addressing) is a method of addressing data on a disk drive. The options are Disabled and Auto . Block (Multi-Sector Transfer) Block mode boosts IDE drive performance by increasing the amount of data transferred.

Only 512 bytes of data can be transferred per interrupt if block mode is not used. Block mode allows transfers of up to 64 KB per interrupt. Select "Disabled" to allow the data to be transferred from and to the device one sector at a time. Select "Auto" to allows the data transfer from and to the device occur multiple sectors at a time if the device supports it. The options are Auto and Disabled. 4-6