Super Micro Computer, Inc. MNL-H8DGT-HF-HIBQF - SR56x0 — Super Micro H8DGT-HF/HIBQF Motherboard User Manual PDF

Chapter 2: Installation Installing the Heatsinks We recommend the use of active type heatsinks (except for 1U systems). Use any onboard fan header for the CPU's heatsink fan. To install the heatsink, please follow the installation instructions that are included with your heatsink package. Note: Make sure the heatsink is placed so that the fi ns of the heatsink are in the direction of the airfl ow in your system. 2-4 Mounting the Serverboard into a Chassis All motherboards have standard mounting holes to fi t different types of chassis. Make sure that the locations of all the mounting holes for both the motherboard and the chassis match.

Although a chassis may have both plastic and metal mounting fasteners, metal ones are highly recommended because they ground the motherboard to the chassis. Make sure that the metal standoffs click in or are screwed in tightly. Check the Compatibility of the Serverboard Ports and the I/O Shield 1. The H8DGT-HF/HIBQF serverboard requires a chassis that can support a board of (LxW) 6.8" x 16.64" (172 x 423 mm) in size. It was designed to be used in a Supermicro 2U Twin system. 2. Make sure that the I/O ports on the motherboard align with their respective holes in the I/O shield at the rear of the chassis. Mounting the Serverboard onto the Tray in the Chassis 1.

Carefully mount the motherboard onto the motherboard tray by aligning the motherboard mounting holes with the raised metal standoffs in the tray. 2. Insert screws into all the mounting holes in the motherboard that line up with the standoffs. 3. Then use a screwdriver to secure the motherboard to the mainboard tray - tighten until just snug (if too tight you might strip the threads). Metal screws provide an electrical contact to the motherboard ground to provide a continuous ground for the system. 2-5 Installing Memory Caution: Exercise extreme caution when installing or removing memory modules to prevent any possible damage. Installing Memory 1.

Insert each memory module vertically into its slot, paying attention to the notch along the bottom of the module to prevent inserting the module incorrectly (see Figure 2-1). 2-7