H8DGT-HF/HIBQF Serverboard User's Manual 2. Install to slots CPU1/DIMM1A, CPU1/DIMM2A, CPU1/DIMM3A and CPU1/ DIMM4A, etc. Populate DIMMs in groups of four per CPU. See support information below. 3. Gently press down on the memory module until it snaps into place. 4. With four DIMMs installed, repeat step 2 to populate the CPU2 DIMM slots. Always install four DIMMs to both CPU DIMM slots for more effi cient operation. Note: The H8DGT-HF/HIBQF serverboards support sixteen (16) memory modules of 1 GB, 2 GB, 4 GB, 8 GB, 16 GB or 32 GB size. It is highly recommended that you remove the power cord from the system before installing or changing memory modules.
Please refer to our web site for memory that has been tested on the H8DGT-HF/HIBQF serverboard. Support The H8DGT-HF/HIBQF serverboard supports single/dual/tri/quad-channel, DDR3-1600/1333/1066 MHz SDRAM. Populating four adjacent slots at a time with memory modules of the same size and type will result in interleaved (128-bit) memory, which is faster than non-interleaved (64-bit) memory. Maximum Memory The H8DGT-HF/HIBQF serverboard can support a maximum memory size of up to 128 GB of ECC/Non-ECC UDIMM or up to 512 GB of ECC RDIMM/LRDIMM SDRAM. Figure 2-1. DIMM Installation To Install: Insert module vertically and press down until it snaps into place.
Pay attention to the alignment notch at the bottom. Notch Notch Front View To Remove: Use your thumbs to gently push the release tabs near both ends of the module. This should release it from the slot. Top View of DDR3 Slot Note: Notch should align with the receptive key point on the slot. Release Tab Release Tab 2-8