Chapter 2: Installation Overheat LED Connect an LED to the JOH1 header to provide warning of chassis overheating. See the table on the right for pin defi nitions. IPMB A System Management Bus header for the IPMI slot is located at IPMB. Connect the appropriate cable here to use the IPMB I2C connection on your system. Unit Identifi er Button A Unit Identifi er (UID) button is located on the rear of the board. There is another UID button located on the control panel. When you push either UID button, both Rear UID and Front Panel UID Indicators will illuminate. Push either button again to turn off both indicators.
These UID indicators provide easy identifi cation of a system unit that may be in need of service. JP3 Adapter Card Connector JP3 Adapter card connector slot provides front access to the power supply, serial ATA and Front Panel Control connections for the H8DGT series motherboards. Plug an Adapter card into this connector to use the functions indicated above. This connector is designed specifi cally for a Supermicro-proprietary adapter card. 2-13 Overheat LED Pin Defi nitions (JOH1) Pin# Defi nition 1 3.3V 2 OH Active IPMB Pin Defi nitions Pin# Defi nition 1 Data 2 Ground 3 Clock 4 No Connection UID Button Pin Defi nitions Pin# Defi nition 1 Ground 2 Ground 3 Button In 4 Ground