omron — Motor Parameters: E2-01 through E2-12 (Manually Entering Parameter Settings)

4.6 Basic Drive Setup Adjustments • High Starting Torque Characteristics, Settings 8 through B Start-Up Programming & Operation • Constant Output Characteristics, Settings C through F 4 Note: Setting an improper V/f pattern may result in reduced motor torque or increased current (due to over excitation). ◆ Motor Parameters: E2-01 through E2-12 (Manually Entering Parameter Settings) In Open Loop Vector Control, motor parameters are set automatically during the Auto- Tuning process. Manually set motor parameters if Auto-Tuning cannot be performed. Refer to Auto-Tuning on page 149 for more information. Refer to E: Motor Parameters on page 314 for a list of motor parameters E2-01 to E2-12.

The following table provides instructions on how to set motor parameters. Refer to the motor data sheet for the correct motor data. ■ Setting Motor Parameters Manually OYMC TOEP C71060622-01-OY V1000 User Manual 137 Setting = 8 50 Hz Setting = 9 50 Hz Setting = A 60 Hz Setting = B 60 Hz 200 (V) Voltage 19 12 0 1.3 2.5 50 Frequency (Hz) 200 (V) 24 Voltage 13 0 1.3 2.5 50 Frequency (Hz) 200 (V) Voltage 24 15 0 1.5 3 60 Frequency (Hz) 200 (V) Voltage 19 12 0 1.5 3 60 Frequency (Hz) Setting = C 90 Hz Setting = D 120 Hz Setting = E 180 Hz 200 (V) Voltage 16 12 01.5 3 6090 Frequency (Hz) 200 (V) Voltage 16 12 01.5 3 60120 Frequency (Hz) 200 (V) Voltage 16 12 01.5 3 60180 Frequency (Hz)