B.2 Parameter Table ◆ o: Operator Related Parameters o parameters are used to set up the LED digital operator displays. 354 OYMC TOEP C71060622-01-OY V1000 User Manual No. Name Description Range Def. Control Mode Addr. Hex Pg. V/f O LV P M o1: Display Settings Use o1 parameters to configure the digital operator display. o1-01 Drive Mode Unit Monitor Selection Selects which monitor will be displayed in the operation menu upon power-up when o1-02 = 5. The monitor parameter number is entered into the spaces provided: U-. For example, set “403” to display monitor parameter U4-03. 104 to 621 106 A A A 500 — Set to U1-06 as a default (Output Voltage Reference).
— o1-02 User Monitor Selection After Power Up Selects the monitor to display upon power-up. 1: Frequency Reference (U1-01) 2: Forward/Reverse 3: Output Frequency (U1-02) 4: Output Current (U1-03) 5: User Monitor (set by o1-01) 1 to 5 1 A A A 501 — o1-03 Digital Operator Display Selection Sets the units to display the frequency reference and output frequency. 0: Hz 1: % (100% = E1-04) 2: r/min (enter the number of motor poles into E2-04/E4-04/E5-04) 3: User defined by parameters o1-10 and o1-11 0 to 3 0 A A A 502 — o1-10 Frequency Reference Setting and User-Set Display These settings define the display values when o1-03 is set to 3.
o1-10 sets display values when operating at the maximum output frequency. o1-11 sets the position of the decimal positions. غغغغغغ o1-10: Sets the first five digits of the value, disregarding the decimal point. o1-11: Sets the number of digits past the decimal point 1 to 60000 A A A 520 — o1-11 Frequency Reference Setting / Decimal Display 0 to 3 A A A 521 —