omron — U: Monitors

B.2 Parameter Table 368 OYMC TOEP C71060622-01-OY V1000 User Manual No. Name Description Analog Output Level Unit Control Mode Addr. Hex V/f O LV P M U4-21 Run Command Source Selection Displays the source for the Run command as XY-nn. X: Indicates which Run source is used: 1 = Reference 1 (b1-02) 2 = Reference 2 (b1-16) Y: Input power supply data 0 = Operator 1 = External terminals 2 = Not used 3 = MEMOBUS/Modbus communications 4 = Option 5 = Not used 6 = CASE 7 = FBD’s nn: Run command limit status data 00: No limit status. 01: Run command was left on when stopped in the PRG mode. 02: Run command was left on when switching from local to remote operation. 03:

Waiting for the soft charge bypass contactor after the power is switched on (UV or UV1 flashes after 10 seconds). 04: Waiting for “Run Command Prohibited” time period to end. 05: Fast-stop (digital input (H1- = 15), operator) 06: b1-17 (run command given at power-up). 07: During Baseblock while coast to stop with timer 08: Frequency reference is below minimal reference during base block 09: Waiting for Enter command A A A 7DD U4-22 MEMOBUS/Modbus Communications Reference Displays the drive control data set by MEMOBUS/Modbus communications register No. 0001H as a 4 digit hexadecimal number.

A A A 7DE U4-23 Option Card Reference Displays drive control data set by an option card as a 4 digit hexadecimal number. A A A 7DF