3.6 Main Circuit Wiring ■ Wiring the Main Circuit Terminal WARNING! Electrical Shock Hazard. Shut off the power supply to the drive before wiring the main circuit terminals. Failure to comply may result in death or serious injury. Note: 1. A cover placed over the DC Bus and braking circuit terminals prior to shipment helps prevent miswiring. Cut away covers as needed for terminals with a needle-nose pliers. A A – Protective Cover to Prevent Miswiring 2. The ground terminal screw on IP20/NEMA Type 1 holds the protective cover in place. Main Circuit Connection Diagram For drive main power circuit connections, refer to Figure 3.3 and Figure 3.4 on page 54 . WARNING! Fire Hazard.
The braking resistor connection terminals are B1 and B2. Do not connect braking resistors to any other terminals. Improper wiring connections could cause the braking resistor to overheat and cause death or serious injury by fire. Failure to comply may result in damage to the braking circuit or drive. 64 OYMC TOEP C71060622-01-OY V1000 User Manual