2 Setting Up a Job in AutoVISION System Components – Mount the camera as required by the application. – Connect the Ethernet cable from "B" on the camera to the network. – Connect the power supply to "3" on the QX-1. – Connect the photo sensor to "T" on the QX-1. – Connect the "Common" cable to "2" on the QX-1 and "A" on the camera. – Plug in the power supply. 2. Select your Vision HAWK in the AutoVISION Connect view, create a job, and adjust camera settings. AutoVISION's Connect view allows you to select your device and configure its settings, and to create a new job. The Select Device dropdown menu provides a list of available devices. Hover the mouse over a device to see its details.
Vision HAWK Smart Camera Guide 2-23