D Serial Commands TRIGGER Triggers an inspection. vt [n] Triggers an inspection by pulsing a Virtual I/O point. For example: vt 1 will return pulse VIO1 . The inspection will run if it is configured to use VIO 1 as a trigger. If specified, the VIO index must be in the allowed range for Virtual I/O points within Visionscape. The virtual I/O line will be set high then low. If VIO Index is not specified, VIO1 is assumed. Fail Return: Return !ERROR followed by the reason for the failure. For example: !ERROR No such trigger when the index specified ‘ n ’ is out of range of virtual triggers. REBOOT [-noload] Reboots the device. -noload = do not load BOOT job.
MEMAVAIL [-cp] Returns available memory for device or coprocessor. MEMCONTIG [-cp] Returns maximum memory block for device or coprocessor. MEMFRAGS [-cp] Returns memory fragments for device or coprocessor. MEMINFO [-cp] [-v] Returns memory summary “avail/contig/frags” for device or coprocessor. Verbose. VERSION Returns Visionscape software version. JOBSAVE [-slot=] Saves current job to slot n . JOBDELETE {[-slot=]n|-all} Deletes job in slot n , or all jobs if -all . Important: Does not delete the current job loaded in camera memory. Vision MINI Smart Camera Guide D-3