Appendix D Serial Commands JOBINFO [[-slot=]n] [-v] Gets job summary or info about slot n . JOBINFO with no arguments returns a list of all jobs on the device. -v = Verbose n . This option shows the amount of space that would be freed if the job were deleted. It also lists the total disk space and free disk space. JOBBOOT [-slot=] Sets bootup job slot n (RS-232 only). JOBDOWNLOAD [-size=value] [-c] Downloads a .avz job file via the specified transfer method (ymodem supported only over RS-232; FTP supported only over network connection).
The ymodem transfer method only requires that the user send the .avz file via the ymodem protocol over RS-232, and the job will load automatically after the transfer is complete. The FTP transfer method requires the user to perform the following steps to load the job: 1. JOBDOWNLOAD: -transfer=ftp [-size=avpsizeinbytes] 2. User FTPs the job to /streamd0 3. JOBLOAD: -mem -r Step 1: Pre-creates a fixed-size /streamd0 RAMdisk to receive the .avz over FTP. If size is omitted, the default RAM disk size is used to create /streamd0. The size of /streamd0 is limited to (available contiguous RAM – minimum target contiguous RAM) / 2. Step 3:
Loads .avz from /streamd0 into RAM, deletes the RAMDisk /streamd0, and optionally starts the job (if -r is specified). JOBLOAD {[-slot=] |-mem} [-r] Loads a job from slot n or from memory when used with the JOBDOWNLOAD command via FTP. -r = Start inspections. SET Sets value of a global tag. The tagname must correspond to one of the supported tags within the device. Use the INFO command to get a full list of tags and services, as well as attributes of the tag and list of subtags. The value can contain spaces. The command is terminated by a carriage return and/or line feed character.
D-4 Vision MINI Smart Camera Guide Camera Model Default RAM Disk Size Minimum Target Continuous RAM Vision MINI 5 MB 7 MB