Average speed The average speed will be displayed on the screen after the starting drive of about 100 me- ters. Select the driving data display item – Depending on the information mode selected, this can be done by buttons or to open the selection menu, then by buttons or to select the Driving data. Or directly through the buttons or to open the selection menu and select Driving data. → page 24 Digital speed The current travelling speed (Km/h) is displayed in digital form. Select drive data memory – Select the required driving data (such as aver- age consumption, miles/time travelled, and average speed). Sets the overspeed alarm – Select display -- km/h speed alarm .
– Press the button in the multifunction steer- ing wheel to store the current speed as the alarm speed in the system and activate the warning. – Press the buttons or in the multifunction steering wheel to open the corresponding menu item. – If necessary, the speed can be adjusted in about five seconds with the buttons or in the multifunction steering wheel. Then press the button , or wait a few seconds, to store the speed and activate the alarm. – Select the drive data memory via buttons or in the multifunction steering wheel.
– Press the button in the multifunction steer- ing wheel to confirm, and the selected drive data memory will be displayed in the instru- ment cluster. – If you need to switch off the speed alarm, press the button again to delete the stored speed. Memory from the start If the interrupted driving time is more than two hours, the system automatically deletes the data in the memory. Warnings can be set in the travel speed range from 30 km/h to 250 km/h. Driving data display (multifunction display) Memory since the last refuelling Display and store collected driving and fuel con- sumption data. The system automatically deletes the data in the memory when fuel is added.
Only applicable to models equipped with digital instrument cluster (basic) Memory accumulation The memory collects travel data for any number of one-way trips. Depending on the instrument cluster type, the driving time collected by the memory can be up to 19 hours 59 minutes or 99 hours 59 minutes, and the driving range can be up to 9,999.9km. If the driving time or mileage exceeds any of the three maximum values 1) , the system automatically deletes the driving data from the memory. Please refer to at the start of the chapter on page 13. Driving data (multifunction display) display a va- riety of vehicle driving data and fuel consump- tion data.
Depending on the vehicle, it may show different driving data. The driving data shown depends on the current driving behavior, vehicle condition (e.g. particle catcher regeneration), and driving condition (e.g. city or highway driving). The driv- ing data is determined by the average of differ- ent lengths of road, which means that the cur- rent displayed value may differ from the actual average. Clear the drive data memory – Select the required driving data (such as aver- age consumption, miles/time travelled, and average speed) → page 18. – Press the buttons or in the multifunction steering wheel to open the corresponding menu item.
1) Depending on the instrument cluster model Owner's manual 18 to ns