Supermicro X10DRT-B+ — Supermicro X10DRT-B+ Motherboard User's Manual PDF (Rev 1.0c)

Chapter 2: Installation 2-4 Installing and Removing the Memory Modules Note : Check Supermicro's website for recommended memory modules. CAUTION Exercise extreme care when installing or removing DIMM modules to prevent any possible damage. Installing & Removing DIMMs 1. Insert the desired number of DIMMs into the memory slots, starting with P1-DIMMA1. (For best performance, please use the memory modules of the same type and speed on the same motherboard.) 2. Push the release tabs outwards on both ends of the DIMM slot to unlock it.

UID_LED1 UID SW IPMI_LAN USB0/1 (3.0) LE6 VGA JVRM1 JVRM2 JPG1 JPB1 JWD1 3 2 1 4 CPU1 SLOT1 PCI-E 3.0 X16 BMC_HB_LED1 JPME2 BMC C612 JBAT1 Battery FLASH BIOS TPM/Port80 JTPM1 FAN4 FAN3 SIOM: CPU1 PCI-E 3.0 X16 IPMI CODE CPU2 SLOT2 PCI-E 3.0 X16 Notches CPU1 PCI-E 3.0 X4 SXB2 SXB1 JF2 JF1 JSD1 JBT1 J* S-SATA3 P1-DIMMA1 P1-DIMMA2 P1-DIMMA3 P1-DIMMB2 P1-DIMMB1 P1-DIMMB3 X10DRT-B+ Rev. 1.01 P1-DIMMD3 P1-DIMMD1 P1-DIMMD2 P1-DIMMC3 P1-DIMMC1 P1-DIMMC2 BIOS LICENSE CPU1 PCI-E 3.0 X4 I-SATA0~5 S-SATA0~2 1 CPU1 Release Tabs CPU2 PCI-E 3.0 X24 CPU2 OPEN 1st 1 1 1 3.

Align the key of the DIMM module with the receptive point on the memory BAR CODE P2-DIMMG1 P2-DIMMG2 P2-DIMMG3 P2-DIMMH1 P2-DIMMH2 P2-DIMMH3 P2-DIMMF3 P2-DIMMF1 P2-DIMMF2 P2-DIMME3 P2-DIMME2 P2-DIMME1 slot. 4. Align the notches on both ends of the module against the receptive points on the ends of the slot. 5. Use two thumbs together to press the notches on both ends of the module straight down into the slot until the module snaps into place. 6. Press the release tabs to the locking positions to secure the DIMM module into the slot. Press both notches straight down into the memory slot at the same time.

Removing Memory Modules Press the release tabs on both ends of the memory module to unlock it. Once it is loosened, remove the DIMM module from the memory slot. 2-25