X10DRT-B+ Motherboard User’s Manual 3. HDD support: Make sure that all hard disk drives (HDDs) work properly. Re place the bad HDDs with good ones. 4. System cooling: Check system cooling to make sure that all heatsink fans, CPU fans and system fans work properly. Check Hardware Monitoring set tings in BIOS to make sure that the CPU and System temperatures are within the normal range. Also check the front panel Overheat LED, and make sure that the Overheat LED is not on. 5. Adequate power supply: Make sure that the power supply provides adequate power to the system. Make sure that all power connectors are connected.
Please refer to our website for more information on minimum power require ment. 6. Proper software support: Make sure that the correct drivers are used. B. When the system becomes unstable before or during OS installation, check the following: 1. Installation Devices: Make sure that the devices used for installation are work ing properly, including boot devices such as CD/DVD-ROM. 2. Cable connection: Check to make sure that all cables are connected and working properly. 3. Using minimum configuration for troubleshooting:
Remove all unnecessary components (starting with add-on cards first), and use minimum configuration (with a CPU and a memory module installed) to identify the trouble areas. Refer to the steps listed in Section A above for proper troubleshooting proce dures. 4. Identifying bad components by isolating them: If necessary, remove a compo nent in question from the chassis, and test it in isolation to make sure that it works properly. Replace a bad component with a good one. 5. Check and change one component at a time instead of changing several items at the same time. This will help isolate and identify the problem. 3-4