User's Guide Solving Problems Solving Problems Checking the Printer Status Checking Messages on the LCD Screen If an error message is displayed on the LCD screen, follow the on-screen instructions or the solutions below to solve the problem. 123 Error Messages Solutions Printer error. Turn power of fand on again. For details, see your documentation. If the error message still appears after turning the power off and on again, contact Epson support. Operation canceled. Error while saving. The memory card may be damaged. Check if your memory card is available. You need to replace the following ink cartridge(s).
To ensure you receive premium print quality and to help protect your print head, a variable ink safety reserve remains in the cartridge when your printer indicates it is time to replace the cartridge. Replace the cartridge when you are prompted to do so. Paper Configuration is disabled. Some features may not be available. For details, see your documentation. If Paper Configuration is disabled, you cannot use AirPrint. To use AirPrint, enable Paper Confgi uration. The printer's ink pad is nearing the end of its service life. Please contact Epson Support. Contact Epson or an authorised Epson service provider to replace the ink pad*. It is not a user-serviceable part.
The message will be displayed until the ink pad is replaced. x Press the button to resume printing. The printer's ink pad is at the end of its service life. Please contact Epson Support. Contact Epson or an authorised Epson service provider to replace the ink pad*. It is not a user-serviceable part. Communication error. Connect computer. Connect the computer and the printer correctly. If you are connecting over a network, see the page that describes the network connection method from the computer. If the error message is displayed during scanning, make sure that Epson Scan 2 and Epson Event Manager are installed on the computer. Combination of IP address and subnet mask is invalid.
See documentation. Enter the correct IP address or default gateway. Contact the person who setup the network for assistance. Update the root certifci ate to use cloud services. Run Web Confgi , and then update the root certifci ate. Recovery Mode The printer has started in recovery mode because the frimware update failed. Follow the steps below to try to update the frimware again. 1. Connect the computer and the printer with a USB cable. (During recovery mode, you cannot update the frimware over a network connection.) 2. Visit your local Epson website for further instructions.