ZMM-Sliven C8C CU 325 — ZMM-Sliven C8C CU 325 Universal Lathe Machine Manual PDF

5.3. FEED BOX LUBRICATION 5.3.1 FEED BOX LUBRICATION METHOD The feed box lubrication method is by oil bath splashing. 5.3.2 FILLING THE FEED BOX WITH OIL 5.3.3. OIL LEVEL The oil level should be maintained in the middle of oil level indicator glass. 5.3.4. OIL LEVEL VERIFICATION AND OIL ADDITION Before every machine start and 10 – 15 minutes after machine shut down verify the oil level on the oil level indicator glass. If necessary, add oil to the middle of oil indicator glass. Warning: Do not operate the machine if the oil level is below middle of oil level indicator glass. Also avoid excessive oil in the feed box (over the middle of oil level indicator glass).

5.3.5 FEED BOX OIL CHANGE Recommended periods for feed box oil change: First change: 10 – 15 workdays after machine start up. Second change: 20-30 workdays after first change. Then: in a 2 -3 work months periods. Hint: It is recommended that before fill new oil wash the feed box with suitable washing liquid commercially available. 5.4 APRON, BED SLIDE WAYS, LEAD SCREW AND SHAFT LUBRICATION 5.4.1. METHOD OF LUBRICATION Apron mechanisms are lubricated by oil bath splashing. C:\Users\ELENA\Desktop\UL_C8C_325_ENG.doc 36/67 Lathe model C8С CU325 Oil viscosity grade CL32 acc. DIN51502 or CB32 acc. ISO3498-1979 (See Table 5-1) Quantity 0,75 Litre 0,75 Litre