6 MACHINE MAINTENANCE 6.1 MACHINE LUBRICATION The lubrication is of great importance for machine trouble free operation and long life. Machine lubrication and oil change must be strictly observed as instructed under section 5. “Machine lubrication”. 6.2 ADJUSTMENTS All machine mechanisms are factory adjusted and tested. However, after a long time of operation or after repair works some mechanisms or machine parts have to be checked and properly adjusted. 6.2.1. ADJUSTMENT THE CLUTCH FOR FORWARD AND REVERSE ROTATION The forward and reverse spindle rotation double-stack clutch type “Sigma” (See Fig.6-1) contains two disc stacks “A” and “B” located each side of shifting ring 1.
Disc stack “A” (close to V-belt pulley) serves to transmit forward rotation to spindle and disc stack “B” (far from V-belt pulley) serves to transmit reverse rotation to spindle. Between-disk clearance is factory adjusted so that full rotation torque is transmitted to spindle without idle slippage between discs. However, it may be necessary to adjust the clearance between discs resulted from normal disc wear so that no idle slippage occurs when transmitting the rotation torque to spindle. Procedure: Switch off the power supply from electric cabinet main disconnector. Remove the cover from gearbox top.
Adjustment the between-disc clearance on disc stack “A” (spindle forward rotation) Pull and turn at 90 о the fixer 2 that secure adjusting nut 3 to pressing disc 4. At this position the adjusting nut 3 should be free from the pressing disc and can be turned for adjusting. Into one of the adjusting nut 3 holes insert a metal rod 5. Turn the nut in direction from machine to you as much as necessary to eliminate the excessive between- disc clearance. When the excessive clearance is eliminated (up to you) pull back fixer 2 so that it just set up its place and proper secure adjusting nut 3 to the pressing disc 4.
If necessary, you can make it easier by shifting the clutch to stack “B” first , then manually turn V-belt pulley. Warning: Before machine start it is important to verify if the fixer 2 is properly set on its place and secure adjusting nut 3 to pressing disc 4. Verification of the adjustment C:\Users\ELENA\Desktop\UL_C8C_325_ENG.doc 41/67