Switch on the power supply and start the motor; Set the clutch control lever for spindle forward rotation and verify the following: i. If the clutch control lever can be moved easy and the spindle smoothly starts forward rotation means that between-disc clearance is correct adjusted; ii. If however, the clutch control lever cannot be easy moved and the spindle starts harshly (with a jerk) forward rotation means that the clutch discs are tightened and shall be fast wear out. In this case it is necessary to loose the discs to some extent by turning the adjusting nut 3 backward so that described in “i” above effect be achieved.
Adjustment the between-disc clearance on disc stack “B” (spindle reverse rotation) The adjustment procedure is same as described for disc stack “A” above with the only exception that the adjusting nut 3 must be turned in direction from you to the machine. Fig.6-1. Clutch for spindle forward and reverse rotation C:\Users\ELENA\Desktop\UL_C8C_325_ENG.doc 42/67