ZMM-Sliven C8C CU 325 — ZMM-Sliven C8C CU 325 Universal Lathe Machine Manual PDF

6.2.2 BAND BRAKE ADJUSTMENT Band brake adjustment is necessary if after setting the clutch control lever in middle position (clutch inactive) the brake does not stop spindle within limited time or after replacement wear out brake band. Adjustment procedure for Model С8С (See Fig.6-2) Switch off the power supply from electric cabinet main disconnector. Remove the cover from gearbox top. Loose adjusting nuts 4 so that the excessive clearance between band linen 3 and brake drum be eliminated; Spring 5 provides the pressure required. If linen 3 found wear out it must be changed by new one.

Fig.6-2 Band brake adjustment Verification of the adjustment Dismount the universal chuck from the spindle and check to verify that: When the clutch control lever is set on middle position spindle (without chuck) stops running at maximum speed within 6 – 7 seconds. Warning: Do not tighten the band so that no clearance exists between the band 3 and brake drum 4 that may lead to fast wear out and heat generation. . C:\Users\ELENA\Desktop\UL_C8C_325_ENG.doc 43/67