Adjustment procedure for Model СU325 (See Fig.6-3) Switch off the power supply from electric cabinet main disconnector; Remove the screw that fix electric cabinet right side to gearbox; Swing the cabinet out of gearbox side; Remove 6 mounting screws from the lid that cover the opening for access to the band brake. Remove the lid; Loose lock nut 1; Tighten adjusting nut 2 as much as necessary to eliminate the excessive clearance between band 3 and brake drum 4. Tighten lock nut 1 so that adjusting nut 2 is properly locked. Verification of the adjustment Dismount the universal chuck from the spindle and check to verify that:
When the clutch control lever is set on middle position spindle (without chuck) stops running at maximum speed within 6 – 7 seconds. Fig. 6-3. Band brake adjustment Warning: Do not tighten the band so that no clearance exists between the band 3 and brake drum 4 that may lead to fast wear out and heat generation. C:\Users\ELENA\Desktop\UL_C8C_325_ENG.doc 44/67