ZMM-Sliven C8C CU 325 — ZMM-Sliven C8C CU 325 Universal Lathe Machine Manual PDF

6.2.7 TAILSTOCK SIDE DISPLACEMENT (See Fig.6-9 and Fig.6-10) When a long workpiece with a long taper shape to be machined the tailstock 6 upper part can be displaces sidewise in relation to lower part 5. The displacement value is read out on a scale located on tailstock rear side. One graduation of the scale is equal to 1 mm displacement to the left or right. Procedure: Unclamp the tailstock by handle 1; Loose screw 2; When adjusting screw 3, Fig.6-10 is screw in or screw off the tailstock upper part moves to the front or rear guide prisms i.e. left or right from the scale zero; When the desired displacement is set then tighten screw 2 to fix it. Warning:

After operation with tailstock displaced sidewise it is of grate importance to recover the initial setting. Also measure by dial indicator and arbor to ensure exact alignment between tailstock and headstock. Fig.6-9. Tailstock sidewise displacement C:\Users\ELENA\Desktop\UL_C8C_325_ENG.doc 50/67