6.2.6. ADJUSTMENT THE CLEARANCE BETWEEN LOWER SLIDE AND CARRIAGE BASE PLATE (See Fig.6-8) The clearance between the sliding surfaces of lower slide 1 and carriage base plate 2 is adjusted by gib 3. Use same method to adjust the clearance between upper slide and compound. Procedure To prepare the gib 3 for adjustment procedure loose fixing screw 4 from slide rear side. To achieve the desired clearance tighten screw 5 as much as necessary; After adjustment fix the gib 3 by tighten lock screw 4; Fig.6-8 Adjustment the clearance between lower slide and carriage base plate Verification of the adjustment:
Check by gap gage the clearance between contact surfaces of lower slide and carriage base plate . The clearance measured should not be greater than 0,03 mm ; The carriage motion should smooth and easy . C:\Users\ELENA\Desktop\UL_C8C_325_ENG.doc 49/67