HOME 52. With engine resting in ENGINE ASSEMBLY SUPPORT FIXTURE (Part No. HD-43517), gently pull on handles to work engine partially out of left side of frame. sm02006 53. See Figure 2-14 . Pull connectors to neutral light sender [131] under drive sprocket. NOTE The neutral light sender stays in the engine. 54. Pull purge solenoid hose off of charcoal canister (California models only). 55. See Figure 2-15 . Pull connectors from stoplamp switch [121] for VRSCAW models. 56. Pull electrical harness to stoplamp switch and purge solenoid hose (California models only) through top of the cavity in engine cases. Figure 2-16. Vehicle Speed Sensor Connector [65] 57. See Figure 2-16 .
Disconnect vehicle speed sensor wire from connector [65] at vehicle speed sensor. 1. Verify VIN of replacement engine. 2. Check replacement/overhauled engine for: a. Vehicle speed sensor and wiring. b. Neutral sending switch. c. Ground cable. 2009 VRSC Service: Chassis 2-19 NOTE The vehicle speed sensor and wire connector [65] stay attached to the engine. 58. With fixture handles, pull engine out of frame onto left side extension. 59. See Figure 2-17. Engine may be secured with straps for hoisting. 60. If replacing engine with a new engine, proceed to 2.7 ENGINE REPLACEMENT, Installation.
If rebuilding engine, mount engine on stand and proceed to 3.8 CAM- SHAFTS, DRIVE CHAINS AND CAMSHAFT TIMING. sm02004 sm02008 Figure 2-17. Engine Strapped for Hoisting INSTALLATION PART NUMBER TOOL NAME HD-45317 ENGINE ASSEMBLY SUPPORT FIX- TURE TOOL NAME ENGINE ASSEMBLY SUPPORT FIX- TURE