F3B ENGINE 213 T RAKKER E URO 4/5 PRINT603.93. 641 Fitting connecting rod - piston assemblies in cylinder liners Figure 178 Figure 176 60616 Turn the cylinder block, setting it upright. Lubricate the pistons, piston rings and inside the cylinder liners. With the aid of the clamp 99360605 (1) mount the connecting rod q piston assemblies (2) in the cylinder liners according to Figure 177. Check that: 49030 NOTE Not finding it necessary to replace the connecting rod bearings, you need to fit them back in exactly the same sequence and position as in removal.
Choose main bearings, if they are to be replaced, based on selection described in chapter kSelecting main and big end bearings y. - The number of each connecting rod corresponds to the cap coupling number. - The symbol (2, Figure 177) punched on the top of the Lubricate the bearing shells (1 and 3) and fit them on the connecting rod (2) and on the cap (4). pistons faces the engine flywheel or the recess in the piston skirt tallies with the position of the oil nozzles. NOTE NOTE Do not make any adjustment on the bearing shells. The pistons aresupplied as spares in class A and can also be fitted in class B cylinder liners.
Figure 177 1 Connecting rod q piston assembly 2 Area of punch marking on the top of the piston with the symbol for the mounting position and selection class. 3 Area of connecting rod punch marking 60615 Print 603.93.641 Base q November 2006