TRAY UP/DOWN Q5690A 17. Remove the E-ring [1] and then remove the drive pulley [3] while releasing the winding of the [9] [8] [10] [11] 18. Remove the up/down wire /A [2] from the up/ up/down wire /A [2]. [2] [12] [2] down drive shaft [4]. 19. Remove the up/down wire /A [2] from the guide [6] pulleys [5], [6] and [7]. Note: • When removing the up/down wire A [2] [2] installed onto the guide pulleys [5], [6] and [7], be sure to pull out the wire from a notch [8] [5] provided on the side of each pulley to move the wire cover [9] of each pulley to the loca- [7] tion where the notch [8] can be avoided. [4] 20. Remove a screw [10] and then remove the up/ [3] down wire protective cover [11].
[2] [3] III DIS./ASSEMBLY 21. Pull out the up/down wire A [2] from the upper surface [12] of the HCI engine to remove it. [9] [1] [8] [2] [4] 22. In the same manner as Steps 12 to 16, remove the up/down wire A [1] on the rear side. [1] 23. In the same manner as Steps 17 to 21, remove the up/down wire A [2] on the rear side. [2] 3-18