FilteringClippingMode FilteringClippingMode VPARAMETER 5370 Sets the clipping mode applied by a filtering operation. Typically, the hsClippingAbsolute mode is used for filter operations. Syntax Micro V+ VPARAMETER (sequence_id, tool_id, 5370, index_id, object_id) = value value = VPARAMETER (sequence_id, tool_id, 5370, index_id, object_id) V+ VPARAMETER (sequence_id, tool_id, 5370, index_id, object_id) $ip = value value = VPARAMETER ($ip, sequence_id, tool_id, 5370, index_id, object_id) Remarks hsClippingNormal mode forces the destination pixel value to a value from 0 to 255 for unsigned 8-bit images, to a value from -327678 to 32767 for signed 16 bits images, and so on.
Values that are less than the specified minimum value are set to the minimum value. Values greater than the specified maximum value are set to the maximum value. hsClippingAbsolute mode takes the absolute value of the result and clips it using the same algorithm used for hsClippingNormal mode. Range Parameters ACE Reference Guide, 18317-000 Rev A Page 232 Value Image Processing Clipping Mode Description 0 hsClippingNormal Normal clipping method is used. 1 hsClippingAbsolute Absolute clipping method is used. $ip IP address of the vision server. Applies to V+ syntax only. Uses standard IP