AH Motion Controller – Operation Manual 4.5.4 Basic Editing - Selection of a Network and Operation Before an object in a network is selected, users have to press Esc on the keyboard, or click on the toolbar. After the cursor appears as a small arrow, you can click the object in the network. The basic selection is shown below. Selecting the network Selecting the input contact Selecting the network Selecting the output coil Selecting the block If you want to select a group of devices, you can click a device, and drag it to draw a frame round the group of devices. device, and pressing Ctrl+B on the keyboard.
You must draw a frame round devices which are in the same network, and You can also select the group of devices by clicking the first device, pressing Ctrl+B on the keyboard, clicking the last _4 the devices must be adjacent to one another. Besides, input devices and output devices can not be in the same frame. If you want to select several networks, you can press Ctrl on the keyboard, and click the networks. You can also select a range of networks by pressing Shift on the keyboard, clicking the first network within the range, and the last network within the range. 4-26