Chapter 9 Ethernet Communication Module AH10/15EN 9-11 #611 Reserved #612 ~ #627 W Sending commands to the connection 1~16 One word represents one connection of a remote device. Input a command code to send the command and work with CR#644~CR#649 to write the parameters in.
#628 ~ #643 Reserved #645 #644 W Command information object address (IOA) Information object address (IOA) of the connection to be written with a command #647 #646 W Command value The value of the connection to be written with a command #649 #648 W Command SV The 2nd value of the connection to be written with a command (according to the requirement of the data type; if there’s no requirement, leave it blank.) #650 W Data point number of the slave station Data point number of the data type to be created #651 W Data point type identification of the slave station The data point type to be created #653 #652 W Data point Information object address (IOA) of the slave station The IOA of the to be created data point #654 W Data point group mask of the slave station The mask of the to be created data point #655 W Data point flags of the slave station The flags of the to be created data point #657 #656 W Data point value of the slave station The default value of the to be created data point #658 W Data point of the slave station for data mapping The corresponding register number (D or M) of the PLC to the data point to be created #659 W Data point of the slave station for data mapping 1:
enable the settings of the data point for one time; after it is done, resets it to 0. #665 ~ #660 Reserved #666 W Setting up the database of the slave station 0: reset this setting 1: enable the settings of the database; after it is done, reset it to 0.
#667 Reserved #668 R Counter register for the data point of the slave station The number of the already used data point #669 R The status of remote device The number of connected master devices #671 #670 Reserved #672 ~ #684 R/W CPU register number corresponding to the master connection 1 One word represents one data type; the written code is the corresponding register number of the data type #697 ~ #685 R/W CPU register number corresponding to the master connection 2 #710 ~ #698 R/W CPU register number corresponding to the master connection 3 #723 ~ #711 R/W CPU register number