DETAILED STEPS Procedure Application Hosting Configuring the AppGigabitEthernet Interface for ERSPAN Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. Enter your password, if prompted. Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Step 3 vtp mode off Example: Device(config)#vtp mode off Sets the VTP-device mode to Off for VLANs. Step 4 vlan {vlan-ID | vlan-range} Example: Device(config)# vlan 2508 Adds a VLAN and enters config-VLAN configuration mode. Step 5 exit Example: Device(config-vlan)# exit Exits config-vlan configuration mode and returns to global configuration mode.
Step 6 interface vlan vlan-ID Example: Device(config)# interface vlan 2508 Creates a dynamic Switch Virtual Interface (SVI) and enters interface configuration mode. Step 7 ip address ip-address mask Example: Device(config-if)# ip address 192.0.2.1 255.255.255.252 Configures an IP address. Step 8 no shutdown Example: Device(config-if)# no shutdown Restarts a disabled interface. Step 9 exit Example: Device(config-if)# exit Exits interface configuration mode and returns to global configuration mode. Step 10 interface AppGigabitEthernet number Example: Device(config)# interface AppGigabitEthernet 1/1 Configures the AppGigabitEthernet and enters interface configuration mode.
For stackable switches, the number argument is switch-number/0/1. Application Hosting 29