Delta Electronics — 6.19.2 Explanation of Communication Instructions

AS Series Programming Manual RTU mode  AS sends the communication command: “01 05 05 00 FF 00 8C F6”  AS receives the communication command: “01 05 05 00 FF 00 8C F6” If the format is correct, SM100 is ON. 3. After receiving the data from the DVP-ES2, the PLC confirms the data format sent back from the DVP-ES2 and determines if it is correct. If no error occurs in the format, the corresponding special flags SM100 are ON; if not SM102 is ON. 4. When the DVP-ES2 receives this instruction, the Y0 is ON. 5. Since this function code writes data, the operand n is ignored. Example 4 1. Function code 06 (16#06): the PLC writes the state into a word device. _6 2.

AS Series CPU module is connected to the DVP-ES2 series PLC. 3. Suppose D10 is 16#55AA (waiting to write data to the device T0 of the DVP-ES2). When SM96 and X0.0 are ON, the PLC can write data to the T0 of the DVP-ES2 series PLC. The address of T0 is 16#0600. 6-556