Features and Differences Features and Differences This section describes the features and limitations of the ACE emulation mode. Features The emulation mode provides the following features and benefits: l Create applications offline If no hardware is available, you can still create your application offline. The emulation mode allows you to configure a workspace with robots, belts, feeders, and other hardware. When the physical hardware becomes available, you can transition from the virtual hardware to the physical hardware l Program offline You can open and edit existing ACE workspaces, and view and edit V+ programs in the workspace.
l Operate applications offline If you have an existing workspace, you can open that workspace and run an application "virtually" (without the physical hardware). The application runs in an emulation mode and uses the 3D Visu- alization feature to simulate the behavior of the system. l Experiment with products/hardware Because the emulation mode application is created with virtual hardware, you can experiment with different cell designs and layouts before purchasing the physical hardware. l Train without hardware The emulated environment provides a convenient and low-risk method for training technicians, operators, and other system users.
Differences The emulation mode has the following differences: l Saving data to the emulated controller is not supported. When emulation mode is enabled, do not save any data to the emulated controller (Disk>D: SD Card). When using emulation mode, ACE creates a new ("fresh") emulated-controller file system in a temporary folder. When ACE is shut down, that file system is deleted, which means the con- tents of any user-created folders, files, or data will also be deleted. Therefore, you should save your data in a PC folder and/or with the ACE workspace.
l No automatic import of robots when creating a new controller When emulation mode is enabled, the Create a New Controller wizard does not automatically import robots. Rather, it prompts you to select the robot(s) connected to the controller. For details, see the figure Configure Robots Prompt on page 1094. l Unavailable controller and robot features are disabled ACE User's Guide, 3.6.x, 18316-000 Rev A Page 1091