Progressive Processing of Pallets Progressive Processing of Pallets In a typical application, you will likely have only one controller associated with each encoder. However, in some applications, you will have multiple robots on different controllers to process parts or targets in pal- lets. In this configuration, each controller will have an encoder wired into the controller and a single latch signal wired into all controllers. The latch signal is used to detect the pallet; the encoders are used to mon- itor the belt movement. As the pallet progresses along the belt, it gets "passed" between robots on all controllers.
In this con- figuration, all controllers must have an entry under one encoder object (in the Encoders table of the Belt editor), as shown in the following figure. NOTE: Not all latching applications require tracking like this. The "latch tracking" method is required only if multiple robots can fill the same pallet positions, and the system has to track the status of each pallet (i.e., what pallet positions are filled) across a controller boundary. ACE User's Guide, 3.6.x, 18316-000 Rev A Page 817 Item Description (Error message) If there is a configuration error, an alert icon ( ) displays in the corresponding controller row.
If you hover the mouse pointer over the icon, a message displays that describes the error. For example: For more details on configuration messages and their associated codes, see Status/Error Codes on page 932.