Code and Description List ACE User's Guide, 3.6.x, 18316-000 Rev A Page 935 Code Description C R G CV BE L F P PT Pa Cs O -20111 '{0}' has not been calibrated to the latch for belt '{1}'. x x -20110 '{0}' does not identify a vision tool in the belt properties. x x -20109 '{0}' has not been calibrated to '{1}'. x x -20108 '{0}' has not been calibrated to the belt cam- era '{1}'. x x -20107 '{0}' has not been calibrated to '{1}'. x x -20106 '{0}' does not defined the pallet in the pallet properties. x -20105 '{0}' uses vision tool that does not reference a virtual camera. x -20104 '{0}' does not define the vision tool being used. x -20103 '{0}' does not identify a Belt.
x -20102 Robot is not defined in process. x x -20101 Part target not defined in the process. x x -20100 Part not defined in the process. x x -20027 Unable to retract the gripper tip x -20026 Unable to extend the gripper tip x -20025 The refinement operation did not detect the expected latch signal. x x -20024 Failure in the execution of the refinement vis- ion tool x -20023 There are too many results from the refine- ment operation x -20022 There are no results from the refinement oper- ation x -20021 The refinement operation has timed-out x -20020 The specified robot main control program does not exist. x