Auto starting the application: a. Select Task 0. b. Click the Start icon ( ) to start that program. The robot will move to the Safe location and then begin executing the pick and place cycle. c. To stop the program, click the Pause icon ( ). The robot motion stops. Auto starting the application: After you complete the application sample, you have the option of "auto starting" it. The autostart option allow the application to load and prepare for operation when the robot is powered-up. To enable the autostart option: 1. In ACE, open the Monitor window and type the following command at the dot prompt: ENABLE AUTOSTART 2. Save the ACE workspace. 3. Turn off high power to the robot. 4.
Turn on high power to the robot. 5. After the robot boots up, the white button on the Front Panel blinks. Press the button to complete the power-up process. 6. Enable signal 2010 to activate the application. This can be done by starting the ACE software, and using the Digital I/O panel to activate soft signal 2010. For more details on the Digital I/O panel, see Digital I/O Window on page 166. ACE User's Guide, 3.6.x 18316-000 Rev A Page 960