00-18 POWER TAKE OFF 6. Control Cable Legend 1. Rod end ball portion 2. Control cable 3. Lock nut 4. Special nut 5. Cable holder Because the tip portion (PTO side) of the con- trol cable is of a rod end ball type as shown in the drawing, remove the cable end portion from the cable connector groove on the PTO side sliding it along the groove. Installation Steps 1. Control Cable Set the dump lever to the “Down” position and lock it. Install the control cable assembly in the truck. Move the lock nut (PTO side) and special nut of the cable top the truck front side. NPA0034E Legend 1. PTO 2. Rod end ball portion 3. Cable holder 4.
Cable connector groove Remove the cable holder from the control ca- ble. NPA0036E Remove the control cable assembly from the truck. Legend 1. Special nut 2. Control cable 3. Truck front 4. Lock nut 2. Cable Holder Assemble the cable holder in the control cable. NPA0035E