Ground cable Fuel evaporation system .......................... .................. detach, attach (step 19). unbolt, bolt on at intake manifold (step 20). Accelerator control ...................... disconnect, connect Bowden cable, adjust (step 21). Fuel lines ............................. detach, attach (step 22). Coolant hose, heater supply line ............ detach, attach (step 23). Vacuum line, brake booster ................ detach, attach (step 24). Air conditioning compressor (425) ........... AC compressor can be unbolted with the lines connected and without draining the system (steps 25 to 34). Note On vehicles with air conditioning, the Engine hoist ...........................
attach to suspension lugs, detach (step 35). Guard plate ........................... insert between component compartment and engine, remove (step 37). Exhaust system (48) . . . . . . . . . . . . . unbolt at exhaust manifold and transmission mount 39) 25 Nm. (51) bolt on (steps 38 and Lambda sensor ........................ remove, install (step 40). Engine supporting bracket (12) ............. unbolt, bolt on (step 42). Tightening torques: Bolt (1) 25 Nm, Nut (2) 70 Nm. Drive shaft to transmission (2) . . . . . . . . . . detach, attach, replace self-locking nuts (7a) (step 44). Clamping nut (2a) ....................... loosen, tighten (step 45), 45 Nm. Speedometer shaft .....................
disconnect, connect to transmission (step 46). Ground cable at transmission Shift rods at transmission ................. ............... disconnect, connect (step 47). detach, attach (step 48). Cable connector for starter lockout, backup light switch ............................ unplug, plug in (step 49). Cable for Front engine mounting (22) kickdown solenoid valve ................ ........... disconnect, connect (step 50). unbolt, bolt on at bottom (step 51), 40 Nm. 01 0904 -03012