TRANSMISSION Ch 2 page 128 Heat up the bearing inner ring of the taper roller bearing (approx. 120° C). Figure 357 Assemble the bearing inner ring (1) until contact. WARNING Use safety gloves! Adjust the bearing inner ring after cooling down! Figure 358 Heat up the internal teeth of the idler (1) (approx. 120° C). Figure 359 Install the inner disc carrier (1) into the idler (2) until contact is obtained and fasten it with the retaining ring (3). WARNING Use safety gloves! Adjust the disc carrier after cooling down! Figure 360 SHOP MANUAL CAUTION CAUTION