Ch 2 page 145 TRANSMISSION Assemble the bearing inner ring (1) until contact. Use safety gloves! Adjust the bearing inner ring after cooling down! Figure 423 Install, align and grease the rectangular rings 42x2.5 (1). Figure 424 NOTE Check closing and opening of the clutch by means of compressed air at the hole (see arrow). Closing and opening of the clutch must be clearly audible. Figure 425 Insert clutches ”E“ into mounting device II. See marking on the mounting device! (S) Mounting device II 850317-00077 Figure 426 SHOP MANUAL WARNING CAUTION NOTE