Ch 2 page 165 TRANSMISSION Use grease to fix the axial washer 80x105x1 (1) to washer (2). By means of a suitable pressure piece the washer (2) must be pressed until contact is obtained, i.e. until the snap ring has engaged into the recess of the washer. Figure 501 NOTE Both ends of the snap ring must be located in one of the four mounting holes (see arrows)! The snap ring must be engaged into both recesses ofshaft and gear! Figure 502 Heat up the bearing inner ring of the taper roller bearing (approx. 120° C). Figure 503 Assemble the bearing inner ring (1) until contact. WARNING Use safety gloves! Adjust the bearing inner ring after cooling down! Figure 504 SHOP MANUAL CAUTION