Ch 2 page 213 TRANSMISSION Install the guide pin, the guide ring and the pressure piece until contact. (S) Assembly fixture 850317-00071 Figure 682 By means of the assembly fixture preload the cup spring under a press and engage the guide ring into the annula groove of the cover. Check seat of the guide ring! Figure 683 Installation position of cup spring and guide ring 1 = Cover 2 = Piston 3 = O-ring 290x3 4 = O-ring 214x3 5 = Guide ring (L-ring) 6 = Cup spring Figure 684 Heat up the bearing inner ring of the ball bearing (approx. 120°C). WARNING Use safety gloves! Figure 685 SHOP MANUAL NOTE