Ch 2 page 217 TRANSMISSION Output to front and rear axle Output to front axle with axle insert LKV Install shaft seal 85x120x12 (1 ) by means of the driver tool with sealing lip showing to the oil sump (see Figure 698) (S) Driver tool 850317-00093 Wet outer diameter (rubber coated) with spirit! NOTE Exact installation position is obtained when using the specified driver tool (S)! Figure 698 Legend (Fig. Figure 699) 1 = Transmission housing 2 = Shaft seal 85x120x12 3 = Taper roller bearing 4 = Planet carrier 5 = Output shaft Figure 699 SHOP MANUAL