TRANSMISSION Ch 2 page 248 Checking backlash on the slotted nut 23. Place a dial gauge on a groove. 24. Backlash 0.24 mm to 0.44 mm with gear ratio of bevel gear set i = 3.18 mm. Backlash 0.26 mm to 0.49 mm with gear ratio of bevel gear set i = 3.5 mm. If the required backlash is not reached, replace the disk as specified below: • In case of an insufficient backlash, - install a thicker shim. - Install a thinner shim for differential bearing rolling torque. • In case of an excessive backlash, - install a thinner shim. - Install a thicker shim for differential bearing rolling torque. Figure 808 Checking contact pattern 25. Rotate pinion several times in both directions. 26.
Loosen hexagon screws. 27. Remove the housing with Lifting beam and crane. Figure 809 28. Remove differential from the housing with Extracting device K9005604, Eyebolt 940301-14681 and crane. Figure 810 SHOP MANUAL