Ch 2 page 95 TRANSMISSION Remove the gear (1) and disengage the snap ring (2). Figure 239 Remove the single parts. 1 = Axial bearing cpl. *Axial washers *Axial bearing 2 = Idler 3 = Needle cage 4 = Axial bearing cpl. *Axial washer *Axial bearing *Running disk Gear Figure 240 Pull the bearing inner ring off the shaft. (S) Grab sleeve 850317-00081 Figure 241 Remove the snap ring Fig. 246. On the 4 assembly openings of the gear press the snap ring with a screwdriver flush into the annular groove of the shaft (see arrows Figure 243) and pull off the gear by means of the 3-armed puller at the same time. Figure 242 SHOP MANUAL