MAINTENANCE SECTION 2 Page 29 AIR CONDITIONER FILTER 1. Move the operator’s seat forward, then tilt the backrest forward. 2. Open the panel and loosen screw (1) holding the filter element. Pull out element (2). 3. Install a new element and close the panel. * For the installation of the element, refer to EVERY 100 HOURS SERVICE. 4. Return the operator’s seat to its original position. HYDRAULIC TANK BREATHER 1. Remove cap of oil filler (F) WARNING! When removing the cap, turn it slowly to relieve inner pressure. Remove snap ring on breather (l), then remove breather cap. Replace filter element with a new part, then install cap and snap ring.
It is possible to replace the element with the breather installed in the tank. However. if the breather is removed, do not wrap the taper thread of the breather with seal tape when assembling again. and be careful not to tighten too much. AXLE Front 1. Remove front and rear oil filler plugs (l), then remove drain plugs (2) to drain the oil. 2 Remove front and rear drain plugs (3) and (4) of each side, and drain the oil After draining the oil, tighten drain plugs (2).