Operation Section Automatic Transmission Switch (3 Speed Only) Inching Switch (3 Speed Only) Automatic speed range: . FORWARD: 3 speeds. . REVERSE: 3 speeds. This switch changes over the modes of the inching control pedal, inching and no-inching. DR In this position, the "NO INCHING" mode is selected. In the "NO INCHING" mode, the inching pedal control is disabled but braking function by pushing on the inching pedal is still active. OP In this position, the "INCHING" mode is selected. In the "INCHING" mode, normal inching function is enabled by pushing on the inching pedal. NOTE:
When driving a middle or long distance without using the inching function, set this switch to "DR" position to prevent the transmission clutch pedals from unnecessary wear or overheat. MAN When this switch is in "MAN"(manual) position, travel mode is switched to "MANUAL" and allows operator to choose speeds manually. A-1 ST When this switch is in "A-1 ST "(automatic 1 ST ) position, gears are started from 1 ST speed and changed "AUTOMATICALLY" to the appropriate speed up to the limit set by the gear ratio according to travel load and engine rpm.
A-2 ND When this switch is in "A-2 ND "(automatic 2 ND ) position, gears are started from 2 ND speed and changed "AUTOMATICALLY” to the appropriate speed up to the limit set by the gear ratio according to travel load and engine rpm. 57