ADULT SECTION Maintenance Controls and Linkage All bushings, spindle shafts, and tie rod ends should be coated with a light coat of oil or grease. Throttle and brake controls and cables should be lubricated with Polaris Premium All Season Grease. Force a small amount of lubricant down the cable. Bearings To prevent corrosion which will destroy the bearings, always grease drive shaft clutch side bearings with a high quality bearing grease. Electrical Connections Separate electrical connector blocks and clean corrosive build up from connectors. Lubricate or pack connector blocks with Nyogel t grease and re-connect. Replace worn or frayed electrical wire and connectors.
Be sure wiring harness is properly secured away from sharp edges, steering linkage, moving parts, and hot exhaust. Front Suspension To minimize fatigue on the front shocks and springs during extended storage, it is recommended that the front end of the machine be safely blocked off the ground to remove tension from the shocks and springs. 63