. ATTACHMENTS, OPTIONS HANDLING PAYLOAD METER II (CARD TYPE) *1 *2: Every time the engine is switched ON, the engine operation No. advances by one, and is recorded. The engine operation No. in the cycle data and the engine operation No. in the problem/warning data, which are recorded from the time the engine is switched ON to the time it is switched OFF, are all recorded as an equal value. As a result, when using our personal computer later to compile the data, it is possible to determine what time during the engine operation the cycle data or system problem refers to. When the engine operation No.
is 0, it shows that the problem occurred or was restored when only the power was ON (starting switch key turned to ON), and the engine was not started. 6 - 52 PROBLEM, WARNING DATA When an problem or warning occurs or is restored in the payload meter system, these data are recorded in memory. The maximum limit for problem/warning data is 230 sets o f occur/restore. Item Unit Range Error code Engine operation No.
when occurred Number of times of occurrence since engine was switched ON Year (last 2 digits) Month Day Time Hour Time Min - Integer Times Year Month Day Hour Minute 0 - 65535 1 - 255 0 - 99 1 - 12 1 - 31 0 - 23 0 - 59 See section on "PROBLEM AND WARNING DISPLAY (ERROR CODE)(6-75 PAGE)". (*1) See section on problem/warning display (error code) Engine operation No. when restored Year (last 2 digits) Month Day Time Hour Time Min Integer Year Month Day Hour Minute 0 - 65535 0 - 99 1 - 12 1 - 31 0 - 23 0 - 59 (*2) Shows when problem restored