2. Simultaneously press and hold the “SELECT” and “RESET” buttons, turn the main switch to “ON”, and continue to press the buttons for 8 seconds or more. “SELECT” NOTE: _ All displays on the meter disappear. “dIAG” appears on the LCD meter. “RESET” 3. Press the “SELECT” button to select the CO adjustment mode “Co” 1 or the diagnostic mode “dIAG”. 4. After selecting “Co”, simultaneously press the “SELECT” and “RESET” buttons for 2 seconds or more to execute the selection. 1 5. Check that “Co:01” 1 appears on the LCD meter, and then simultaneously press the “SELECT” and “RESET” buttons for 2 sec- onds or more. 1 6. Change the CO adjustment volume by pressing the “SELECT” and “RESET” but- tons.
NOTE: _ The CO adjustment volume appears on the LCD meter. To decrease the CO adjustment volume, press the “RESET” button. To increase the CO adjustment volume, press the “SELECT” button. 7. Release the “RESET” and “SELECT” but- tons to execute the selection. 8. Turn the main switch to “OFF” to cancel the mode. 3 - 23 ADJUSTING THE EXHAUST GAS VOLUME (For Europe and Oceania) CHK ADJ