HT220 Operator’s Manual Drive - 59 Start Unit 5. Turn ignition switch to the run position (key on, engine off). Cold start wait indicator will light. 6. When cold start wait indicator goes off, turn ignition switch all the way clockwise to start tractor. Warning alarm will sound. Indicators will light. If engine does not start within 20 seconds, release the ignition switch. Allow starter to cool before attempting to start the unit again. If engine does not crank, check battery disconnect. See page 44 for battery disconnect information. Improper control function could cause death or serious injury. If control does not work as described in instructions, stop machine and have it serviced.
NOTICE: If warning alarm does not sound, have machine repaired. 7. Run engine at half-throttle or less for five minutes before operating tractor. During warm-up, check that all controls work properly. IMPORTANT: Some operations will not function if any controls are not in the neutral position upon start up. If some functions do not work, turn ignition key to the off position and ensure that all controls are in the neutral position. CMW